Wegener UNITY4000 Manuale Utente Scaricare il pdf (Pagina 5)

ee--mmaaiill::

[email protected]

vvooiiccee::

360.854.9559

ffaaxx::

360.854.9479

USC-16/SG Installation and Operation Manual

TESTING

TESTING THE STARGUIDE II or III RECEIVER

1 Set your receivers M & C serial port for 9600,8,N,1 via the receivers front panel

keyboard.

2 Connect a Male - Female, DB-9 straight-through serial cable between the M & C

port on the receiver and your computers com port.

* NOTE: Do not use the cables supplied by us!

3 On your computer keyboard, type the following command: VER and press the

ENTER key.

4 If the two are communicating, the details of the current receiver’s software and

other information will be displayed.

5 If your test was successful, remove the Male - Female, DB-9 straight through seri-

al cable from the computer and receiver; proceed to the section labeled “Connecting

the USC-16/SG to your computers serial port”. If your test failed, follow the trou-

bleshooting steps A through G that follows.

TROUBLESHOOTING

A. Build a loop-back “TESTER” by purchasing a “FEMALE” 9 pin D-sub solder

cup connector (Radio

Shack, CompUSA, Local Electronic Store, etc).

B. Solder a jumper between pins 2 & 3.

C. Try typing on the keyboard with nothing connected to the computer’s com port.

You shouldn’t see any characters. If you do, the “ECHO typed characters locally”

is checked (ON)” in the ASCII settings in HyperTerminal. Turn this OFF

(Uncheck) and retest Step C.

D. Plug the “TESTER” into the com port under test

E. Try typing on the keyboard, if you’re using the correct com port, each character

typed will be displayed.

F. If this test fails, try changing com ports on the communication program until you

find the correct port. When a working com port is found, repeat the above test start-

ing at step 1.

TIP

With some communica-

tion programs, any

change made to the pro-

gram settings requires

you to save the changes,

exit the program and

restart the program.

CAUTION!

Broadcast Tools

products, as any elec-

tronic device, can fail

...

NOTE:

If you find that a failure

is traced to the receiver

and ALL receiver trou-

bleshooting has failed.

contact the receiver

manufacture.

1 2 3 4 5 6 7 8 9 10 ... 14 15

Commenti su questo manuale

Nessun commento

Wegener UNITY4000 Manuale Utente Pagina 5

Commenti su questo manuale

Prodotti e manuali riguardandi no Wegener UNITY4000